General Question

tjhogan's avatar

I have four 32 ohm eminence Bass speakers I want to wire them to get a 4 ohm or 2 ohm load is this possible and how?

Asked by tjhogan (3points) October 12th, 2008

I use an Ampeg SVT-VR Bass head you can switch the speaker ohm load from 4 or 2 ohm

Observing members: 0 Composing members: 0

1 Answer

wgallios's avatar

I would guess if they are dual voice coil speakers you would probably want to wire them in parallel/parallel. JL audio has a good guide on wiring speakers to drop the ohms. I believe if you did that you would end up with a 4 ohm load.

http://mobile.jlaudio.com/support_pages.php?page_id=161

Here would be for single voice coils.

http://mobile.jlaudio.com/support_pages.php?page_id=160

wgallios (1768points)“Great Answer” (0points) Flag as…

Answer this question

Login

or

Join

to answer.

This question is in the General Section. Responses must be helpful and on-topic.

Your answer will be saved while you login or join.

Have a question? Ask Fluther!

What do you know more about?
or
Knowledge Networking @ Fluther