General Question

HappyFox's avatar

How can I be sure that my car's head gasket has blown?

Asked by HappyFox (189points) November 3rd, 2009

I have white smoke coming from the exhaust of my car (espeically on start up), and some of my car enthusiast friends have told me that I have blown my head gasket.

My car is a Subaru Impreza, and because of the flat-four engine layout, I’m told that gasket replacement can be expensive due to the need to take the engine out and change the gasket on the other cylinder head at the same time.

Without wanting to go down this possibly expensive road, are there any tests I can do that will confirm that I have blown a gasket?

Observing members: 0 Composing members: 0

7 Answers

FireMadeFlesh's avatar

A blown head gasket will cause the car to overheat easily, and coolant viscosity may increase. This may also indicate a leak in the cooling system, but a simple pressure test should be able to tell you if that is the case. The white smoke may be coolant burning. I’m not sure of any definitive tests for it, but it will be even more expensive if you try to drive with a blown head gasket so it is best if you get an opinion from a trained mechanic before you do anything.

dpworkin's avatar

Sometimes the coolant in the exhaust will condense on the way through the exhaust system, and your tailpipe may drip, but that is far from definitive, since by that time other damage has already been done. If it were my car I would take it in for service.

IchtheosaurusRex's avatar

Get a compression check. This involves removing a spark plug and inserting a gauge in the socket. It’s a fairly quick test that any shop can perform. If you are mechanically inclined, you can pick up a compression gauge and do the test yourself.

The bad news is that it could be worse than a head gasket. You could have a crack in the cylinder block.

filmfann's avatar

If the smoke is a bluish white, it’s probably your head gasket.
Bummer.

When my Subaru did this, (due to the bastards at Jiffy Lube) I got a $800 replaced engine from Japan, and just put a new one in.

Russell_D_SpacePoet's avatar

if your oil on the dipstick looks like chocolate milk after letting the motor run for a couple of minutes, the head gasket is bad or the head is warped or cracked.. The other symptoms you described can be attributed to a blown head gasket or a cracked or warped head. If the car was overheated and the head is aluminum, the the head could be warped. Expensive fix either way. Good luck.

HappyFox's avatar

Thanks to everyone for their responses so far! I’ve managed to get my local mechanic friend to come round tonight, and he has mentioned doing some pressure test on the cooling system as well as a compression test.

My phone call to Subaru for a cost for a replacement gasket = ”...about a thousand quid all-in.” Gulp! :(

majorrich's avatar

There will be 2 headgaskets in your case i’m afraid. If you really like the car (who wouldn’t) You will already past halfway there to go ahead with a rebuild and a more.. uh.. performance cam. Add that bit of off-the-line ‘grunt’. Done it, glad I did. essentially a brand new engine!

Answer this question

Login

or

Join

to answer.

This question is in the General Section. Responses must be helpful and on-topic.

Your answer will be saved while you login or join.

Have a question? Ask Fluther!

What do you know more about?
or
Knowledge Networking @ Fluther